Mazda 6 Owners Manual: To Operate the System
The High Beam Control System (HBC) operates to switch the headlights automatically between high and low beams after the ignition is switched ON and the headlight switch is in the AUTO and high beam position.
The High Beam Control System (HBC) determines that it is dark based on the brightness of the surrounding area. At the same time, the High Beam Control System (HBC) indicator light (green) in the instrument cluster illuminates.
NOTE
- When the vehicle speed is about 30 km/h (19 mph) or more, the headlights
automatically switch to high beams when there are no vehicles ahead or approaching
in the opposite direction.
When the vehicle speed is less than about 20 km/h (12 mph), the High Beam Control System (HBC) switches the headlights to low beams.
- The low beams may not switch to high beams when cornering.
- Operation of the High Beam Control System (HBC) function can be disabled.
High Beam Control System (HBC) (Some models)
The High Beam Control System (HBC) determines the conditions in front of the
vehicle using the Forward Sensing Camera (FSC) while driving in darkness to automatically
switch the headlights between ...
Manual Switching
Switching to low beams
Shift the lever to the low beam position. The High Beam Control System (HBC)
indicator light (green) turns off.
Switching to high beams
Turn the headlight switch to the
p ...
Other materials:
Mazda 6 Owners Manual: Center panel module disassembly/assembly
Caution
Before disassembling the center panel module, spread a cloth on the floor to
put the disassembled parts on. This protects the surface of the panel from
scratches or dirt.
1. Remove the center panel module. (See CENTER PANEL MODULE
REMOVAL/INSTALLATION.)
2. Remove in the order i ...
Mazda 6 Owners Manual: Base installation
1. Cut away all of the original sealant using a razor.
2. Clean and degrease the ceramic coating on the glass and the base.
3. Apply primer to the bonding area of the glass and the base.
Caution
Keep the area free of dirt and grease, and do not touch the
surface or the primer may not prope ...