Voltage Inspection
Note
1. Visually inspect for the following on the MAF sensor.
- If any of the above are found, replace the MAF sensor.
- If the MAF PID value is out of specification, carry out the Circuit Open/Short Inspection.
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Disconnect the MAF sensor connector.
3. Inspect the following wiring harnesses for open or short. (Continuity check)
Open circuit
- MAF sensor terminal A (harness-side) and main relay terminal C (harness-side)
- MAF sensor terminal B (harness-side) and PCM terminal 2AC (harness-side)
- MAF sensor terminal C (harness-side) and PCM terminal 1P (harness-side)
Short circuit
- MAF sensor terminal A (harness-side) and body GND
- MAF sensor terminal C (harness-side) and power supply
- MAF sensor terminal C (harness-side) and body GND
- MAF sensor terminal B (harness-side) and power supply
Mazda 6 Service Manual: Floor covering
FRONT FLOOR COVERING REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION.)
3. Remove the rear seat.
4. Remove the front scuff plates.
5. Remove the rear scuff plates.
6. Remove the console.
7. Remove the front side tri ...
Mazda 6 Service Manual: Sst
Some Ford SST or equivalent are used as SSTs necessary for
engine repair. Note that these SSTs are marked with Ford SST
numbers.
Note that a Ford SST number is written together with a
corresponding Mazda SST number as shown below.
Example (section ST)
Example (except section ST)
...