Mazda 6 Service Manual: Radiator
RADIATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
3. Remove the cooling fan. (See COOLING FAN REMOVAL/INSTALLATION.)
4. Remove the oil hose. (ATX)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
8. Inspect the engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION.)
Radiator cap
Warning
Never remove the radiator cap while the engine is running, or when
the engine and radiator are hot. Scalding coolant and steam may shoot out
and cause serious injury. It may also dam ...
Thermostat
THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive bel ...
Other materials:
Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. Disconnect the high-tension lead.
4. Remove the spark plugs using the plug-wrench.
5. Install th ...
Mazda 6 Service Manual: Replacing Windshield Wiper Blades
When the wipers no longer clean well, the blades are probably worn or cracked.
Replace them.
CAUTION
To prevent damage to the wiper arms and other components, do not try to sweep
the wiper arm by hand.
NOTE
When raising both windshield wiper arms, raise the driver's side wiper arm
first. W ...