Mazda 6 Service Manual: Rear stabilizer removal/installation
1. Remove the rear auto leveling sensor. (See REAR AUTO LEVELING SENSOR REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET.)
Rear lateral link removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing ...
Stabilizer control link inspection
1. Remove the stabilizer control link from the vehicle.
2. Inspect for bending and damage.
3. Measure the ball joint starting torque.
(1) Rock the ball joint stud side to side 10 times.
(2) Ro ...
Other materials:
Mazda 6 Service Manual: Aluminum Wheel Maintenance
A protective coating is provided over the aluminum wheels. Special care is needed
to protect this coating.
CAUTION
Do not use any detergent other than mild detergent. Before using any detergent,
verify the ingredients. Otherwise, the product could discolor or stain the aluminum
wheels.
NOTE ...
Mazda 6 Service Manual: Information on Temporary Tires
Please refer to the sample below.
1. Temporary tires
2. Nominal width of tire in millimeters
3. Ratio of height to width (aspect ratio)
4. Diagonal
5. Rim diameter code
6. Load index & speed symbol
T115/70D16 90M is an example of a tire size and load index rating. Here is an
explanati ...