1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Connect battery positive voltage to the terminal B and ground to the terminal A of the motor.
4. Verify that the rear washer motor operates.
Mazda 6 Service Manual: Pcm removal/installation
Note
For replace the PCM, Setup the WDS and perform the PCM
configuration. (See PCM CONFIGURATION.)
1. Disconnect the negative battery cable.
2. For R.H.D, perform the following procedures.
(1) Remove the front side trim (left-side).
(2) Partially peel back the flower covering.
3 ...
Mazda 6 Service Manual: Engine oil replacement
Warning
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil has cooled.
A vehicle that is lifted but not securely supported on safety
stands is dangerous. It can slip or fall, causing death or serious injury.
Never work around or ...