Mazda 6 Service Manual: Rear wiper arm and blade removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE ADJUSTMENT)
Rear Wiper Arm Installation Note
Clean the rear wiper arm connector shaft using a wire brush before installing the rear wiper arm.
Rear wiper motor inspection
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
3. Disconnect the rear wiper motor connector.
4. Connect battery positi ...
Rear wiper arm and blade adjustment
1. Operate the rear wiper motor to set the wiper in the park position.
2. Set the rear wiper arm onto the ceramics end line.
...
Other materials:
Mazda 6 Service Manual: Bonnet removal/installation
Warning
Removing the bonnet without supporting can be dangerous. The
bonnet may fall and injure you. Always perform the following procedure with
at least another person.
1. Disconnect the windshield washer hose.
2. To remove the bonnet hinge, remove the front fender panel.
3. To remov ...
Mazda 6 Service Manual: Climate control unit disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Wire Disassembly Note
Disassemble the wires in the shown in the figure.
Wire Assembly Note
Assemble the wires to the position as shown in the figure.
...