Mazda 6 Service Manual: Rear wiper motor inspection
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
3. Disconnect the rear wiper motor connector.
4. Connect battery positive voltage to the rear wiper motor terminal A and the ground to a bare metal part of the vehicle and the rear wiper motor terminal B.
5. Verify that the rear wiper motor operates.
6. Disconnect the ground to the terminal B while the rear wiper is operating.
7. Verify that the rear wiper stops in the park position.
- If not as specified, replace the rear wiper motor.
Rear wiper motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE
REMOVAL/INSTALLATION.)
3. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
...
Rear wiper arm and blade removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE
ADJUSTMENT)
Rear Wiper Arm Ins ...
Other materials:
Mazda 6 Service Manual: Indication on Display
The Distance Recognition Support System (DRSS) operation status is indicated
in the active driving display or multi-information display. Regarding malfunctions,
check the vehicle conditions or have it inspected by an Authorized Mazda Dealer
according to the content of the displayed message.
R ...
Mazda 6 Service Manual: Immobilizer System
The immobilizer system allows the engine to start only with a key the system
recognizes.
If someone attempts to start the engine with an unrecognized key, the engine
will not start, thereby helping to prevent vehicle theft.
If you have a problem with the immobilizer system or the key, consult ...