Mazda 6 Service Manual: Spark plug inspection
Caution
- Do not inspect, adjust, or clean the plug gap with a wire brush.
Doing so can damage the platinum tip.
- When cleaning a spark plug with a plug clear, clean the plug
quickly for less than 20 seconds with air pressure below 58.8 kpa {6.0 kgf/cm,
8.5 psi}. Verify that there is no carbon, sand, etc. in the spark plug after
cleaning.
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. ...
Caution
The high-tension leads must be reinstalled to their original
position.Incorrect installation can damage the leads and cause power loss, and
negatively affect the electronic components.
1 ...
Other materials:
Mazda 6 Service Manual: Noise filter inspection
Brake Light Noise Filter
1. Inspect for resistance and continuity between the noise filter terminals
using an ohmmeter.
If not as specified, replace the noise filter.
Rear Window Defroster Noise Filter
Inspect for resistance and continuity between the noise filter terminals
using an ...
Mazda 6 Service Manual: Battery inspection
Battery
Inspect the battery in the following procedure.
Test load chart
Battery positive voltage with load
Back-up Current
1. Verify that the engine switch is at OFF and that the key has been removed.
2. Disconnect the negative battery cable.
3. Measure the back-up current between the n ...