Mazda 6 Service Manual: Variable tumble control system (vtcs) shutter valve actuator inspection
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
2. Disconnect the vacuum hose from the VTCS shutter valve actuator.
3. Connect a vacuum pump to the VTCS shutter valve actuator.
4. Apply vacuum and verify that the rod moves.
- If the rod dose not move, replace the intake manifold.
Variable intake-air system (vis) control solenoid valve inspection (l3)
1. Remove the VIS control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VIS ...
Variable tumble control solenoid valve inspection
1. Remove the variable tumble control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, rep ...
Other materials:
Mazda 6 Service Manual: Purge solenoid valve removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Vacuum Hose Installation Note
Attach the vacuum hose onto the purge solenoid valve until it contacts the
stopper.
Evaporative Hose Installation Note
Attach ...
Mazda 6 Service Manual: Foreword
Outline
The OBD (on-board diagnostic) test inspects the integrity and function
of the headlight auto leveling system and output the results when reqested
by the specitic tests.
OBD test also:
- Provides a quick inspection of the headlight auto leveling system.
- Is usually perfor ...