Mazda 6 Service Manual: Engine speed sensing power steering

General procedures

Wheels and Tires Removal/Installation The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-1 ...

Air bleeding

1. Inspect the fluid level. (See POWER STEERING FLUID INSPECTION.) 2. Jack up the front of the vehicle and support it on safety stands. 3. Turn the steering wheel fully to the left and right several ...

Other materials:

Mazda 6 Service Manual: Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the connectors. 2. Measure the voltage at the theft-deterrent control module terminals as indicated below. 3. Disconnect the theft-deterrent control module connector before inspecting for continuity at terminals L, Q, S, T, a ...

Mazda 6 Service Manual: Front drain hose installation
Caution If the front drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and the headliner, always make sure there is no interference with the front drain hose. Fix any problem if found ...