Mazda 6 Service Manual: No.5 no creep at all

No.4 excessive creep

No.6 low maximum speed and poor acceleration no.7 no shifting

Other materials:

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm system inspection
System Inspection Preparation 1. Verify that the battery is fully charged. With the ignition switch on, verify that the ABS and BRAKE system warning lights goes out after 2.4 seconds. 2. If the lights stays on after 2.4 seconds, the ABS (ABS/TCS) HU/CM detects a failure. Follow the troubles ...

Mazda 6 Service Manual: Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure. 2. Bleed the air from the brake system. 3. Measure the fluid pressure of the master cylinder and the rear brake. If not within the specification, replace the dual proportioning valve. Fluid pressure ...