Mazda 6 manuals

Mazda 6 Service Manual: Rear suspension

Mazda 6 Service Manual / Suspension / Rear suspension

Transverse member removal/installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. Transverse Cover Installation Note 1. Install the transverse cover. 2. Stake area A as shown in the f ...

Rear shock absorber removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Other materials:

Mazda 6 Service Manual: Combine sensor inspection
Caution Be careful and do not allow the lateral-G sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Connect the connector. 2. Turn ignition switch on, verify the voltage between terminals B and E under the following conditions. If not within the specifi ...

Mazda 6 Service Manual: Base installation
1. Cut away all of the original sealant using a razor. 2. Clean and degrease the ceramic coating on the glass and the base. 3. Apply primer to the bonding area of the glass and the base. Caution Keep the area free of dirt and grease, and do not touch the surface or the primer may not prope ...

© 2016-2026 Copyright www.mazda6info.net