Mazda 6 manuals

Mazda 6 Service Manual: Air mix actuator inspection

1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air mix actuator.

2. Verify that the air mix actuator operates as shown below.

e




3. Verify that the resistance between the terminals of the air mix actuator are as shown in the graph.


Air mix actuator removal/installation
1. Disconnect the negative battery cable. 2. Remove the glove compartment. 3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.) 4. Remove in the order indicated in t ...

Airflow mode actuator removal/installation
1. Disconnect the negative battery cable. 2. Remove the glove compartment. 3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.) 4. Remove in the order indicated in t ...

Other materials:

Mazda 6 Service Manual: Oil cooler
LF, L3 1. Remove the under cover. 2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.) 3. Remove the oil filter cover, and drain the engine oil into a container. (See OIL FILTER REPLACEMENT.) 4. Remove in the order indicated in the table.   5. Use a clean rag to wipe off the m ...

Mazda 6 Service Manual: Multiplex communication system
Outline In case the controller area network (CAN) system is malfunctioning, read the DTCs of the following modules, using the SST (WDS or equivalent) to determine the malfunctioning system. - PCM - DSC HU/CM (with DSC) - ABS (ABS/TCS) HU/CM (with ABS (ABS/TCS) - Instrument clus ...

© 2016-2026 Copyright www.mazda6info.net