Mazda 6 Service Manual: Antenna feeder location

Gps antenna removal/installation

1. Disconnect the negative battery cable. 2. Remove the instrument cluster. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. ...

Front antenna feeder inspection

1. Verify that there is no continuity between the front antenna feeder terminals A and B using an ohmmeter. 2. Inspect for continuity between the front antenna feeder terminals using an ohmme ...

Other materials:

Mazda 6 Service Manual: No. 2 all on-board diagnostic functions inoperative
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunctions. If there is a problem, check to make sure connectors, terminals and wir ...

Mazda 6 Service Manual: Three-way catalytic converter (twc) inspection
Note Make sure that no HO2S DTCs have been detected. If detected, this inspection is not applicable for TWC inspection. 1. Connect the WDS or equivalent and monitor PIDs as following. Monitor the right TWC using O2S11 PID for upstream HO2S and O2S12 PID for downstream HO2S. 2. Be ...