Mazda 6 Service Manual: Climate control unit installation
1. Pass each wire through the following routes then connect to A/C unit. (Manual air conditioner)
2. Connect the climate control unit connectors. (Manual air conditioner)
3. Install the climate control unit to the center panel. (Full-auto air conditioner)
4. Install the center panel.
5. Adjust the climate control unit wires. (Manual air conditioner) (See CLIMATE CONTROL UNIT WIRE ADJUSTMENT.)
6. Connect the negative battery cable.
Climate control unit removal
1. Disconnect the negative battery cable.
2. Disconnect the air mix and airflow mode wires from each wire clamp and
link. (Manual air conditioner)
3. Remove the center panel. (See CENTER PANEL MOD ...
Climate control unit disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Wire Disassembly Note
Disassemble the wires in the shown in the figure.
Wire Assembly ...
Other materials:
Mazda 6 Service Manual: Washer fluid-level sensor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Insoect for continuity between the washer fluid-level sensor terminals
using an ohmmeter.
4. Verify that the windshield washer motor operates.
If not as specified, replace the ...
Mazda 6 Service Manual: Hazardous Driving
WARNING
Be extremely careful if it is necessary to downshift on slippery surfaces:
Downshifting into lower gear while driving on slippery surfaces is dangerous. The
sudden change in tire speed could cause the tires to skid. This could lead to loss
of vehicle control and an accident.
When dri ...