Mazda 6 manuals

Mazda 6 Service Manual: Condenser inspection

1. Inspect for cracks, damage, and oil leakage.

2. Inspect for fins clogged by dust.

3. Inspect for bent fins.

Condenser removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.) Caution ...

Refrigerant lines removal/installation
1. Remove the battery. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the washer tank. (L.H.D. only) (See WASHER TANK REMOVAL/INSTALLATION.) 4. Remove the ...

Other materials:

Mazda 6 Service Manual: No.6 windshield fogged
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunctions. If there is a problem, check to make sure connectors, terminals and wir ...

Mazda 6 Service Manual: Vehicle speedometer sensor (vss) removal/installation
Caution Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. If foreign materials are stuck to the VSS, disturbance by magnetic flux can cause sensor output to be ...

© 2016-2026 Copyright www.mazda6info.net