Mazda 6 manuals

Mazda 6 Service Manual: Door lock timer unit id code change

Mazda 6 Service Manual / Body / Power door lock system / Door lock timer unit id code change

Note


Door lock timer unit inspection
1. Measure the voltage at the door lock timer unit terminals (other than terminal 1E and 2W) as indicated below. If not as specified, inspect the parts listed under Action. 2. Disconnect the ...

Transmitter battery replacement
1. Insert a small screwdriver into the slot and gently pry open the transmitter. 2. Press the portion of the battery indicated by A and remove the battery. 3. Install a new battery (CR2025) in ...

Other materials:

Mazda 6 Service Manual: On-board diagnostic test
DTCs Reading Procedure 1. Perform the necessary vehicle preparation and visual inspection. 2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 3. Retrieve DTCs by WDS or equivalent. Pending Trouble Code Access Procedure 1. Perform the necessary ...

Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing the ATF. 1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.) 2. Disconnect the TFT sensor connector. 3. Remove the TFT sensor. 4. Install a TFT senso ...

© 2016-2026 Copyright www.mazda6info.net