Mazda 6 Service Manual: Power door lock system

Power window motor inspection

Drivers Side 1. Disconnect the power window motor connector. 2. Apply battery positive voltage to the power window motor terminals E and F and inspect the operation the power window motor operatio ...

Front door lock actuator inspection

Door Lock Actuator 1. Disconnect the front door lock actuator connector. 2. Apply battery positive voltage to the front door lock actuator terminals and inspect the operation of the front door loc ...

Other materials:

Mazda 6 Service Manual: Seat warmer switch removal/installation
1. Disconnect the negative battery cable. 2. Remove the brake boots panel. (See CONSOLE REMOVAL/INSTALLATION.) 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Seat Warmer Switch Removal Note Squeeze the tabs of seat warmer switch and pull it forwar ...

Mazda 6 Service Manual: Rear lateral link removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...