Mazda 6 manuals

Mazda 6 Service Manual: Dtc table

Note

  • When DTCs not shown in the DTC table are displayed, replace the SAS unit.

  • If the air bag system warning light does not illuminate or remains illuminated when the ignition switch is turned to ON position, inspect and repair the air bag system warning light circuitry and then confirm that the air bag system warning light is operational.

  • The air bag system warning light will flash the DTC pattern for five cycles, and then will remain illuminated until the ignition switch is turned to the LOCK position.





Foreword
Outline The OBD (on-board diagnostic) test inspects the integrity and function of the air bag system and outputs the results when requested by the specific tests. OBD test also: - Pr ...

Pid/data monitor table
...

Other materials:

Mazda 6 Service Manual: Rear door speaker removal/installation
1. Disconnect the negative battery cable. 2. Remove the rear door trim. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Door Speaker Installation Note Attach the speaker with the wiring harness placed in the groove of the door unit panel. ...

Mazda 6 Service Manual: Climate control unit removal
1. Disconnect the negative battery cable. 2. Disconnect the air mix and airflow mode wires from each wire clamp and link. (Manual air conditioner) 3. Remove the center panel. (See CENTER PANEL MODULE REMOVAL/INSTALLATION.) 4. Remove the screws and climate control unit. (Full-auto air conditione ...

© 2016-2026 Copyright www.mazda6info.net