Mazda 6 Service Manual: Egr valve removal/installation
1. Disconnect the negative battery cable.
2. Disconnect the EGR valve connector.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Water Hose Removal Note
- Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
EGR Valve Removal Note
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION)
2. Remove the upper radiator hose. (See RADIATOR REMOVAL/INSTALLATION.)
Purge solenoid valve inspection
Airflow Inspection
Note
Perform the following test only when directed.
1. Disconnect the negative battery cable.
2. Remove the purge solenoid valve. (See PURGE SOLENOID VALVE
REMOVAL/INSTAL ...
Egr valve inspection
Operation Test
Carry out the EGR Control Inspection. (See EGR Control System
Inspection.
If not as specified, perform the further inspection for the EGR valve.
Resistance Inspection
Note
...
Other materials:
Mazda 6 Service Manual: Recommended Tire Inflation Pressure
On the tire label you will find the recommended tire inflation pressure in both
kPa and psi for the tires installed as original equipment on the vehicle. It is
very important that the inflation pressure of the tires on your vehicle is maintained
at the recommended pressure.
You should check t ...
Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket.
2. Disconnect the DSC HU/CM connector.
3. Connect the SST (49 G066 004) to the DSC HU/CM connector and
harness side connector.
4. Inspect voltage referring the table below.
Terminal Voltage Table (reference value)
(Ignition switch is at ON, and conne ...