Mazda 6 manuals

Mazda 6 Service Manual: Engine

Rear oil seal
REAR OIL SEAL REPLACEMENT 1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION) 2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION) 3. Remove in the order indicat ...

Engine removal/installation
Warning Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakage are dangerous. Fuel c ...

Other materials:

Mazda 6 Service Manual: Overheating
If the high engine coolant temperature warning light turns on, the vehicle loses power, or you hear a loud knocking or pinging noise, the engine is probably too hot. WARNING Pull over to a safe location, then switch the ignition off and make sure the fan is not running before attempting t ...

Mazda 6 Service Manual: Joint shaft removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor and fix it to an appropriate place wh ...

© 2016-2026 Copyright www.mazda6info.net