Mazda 6 Service Manual: Engine disassembly/assembly
1. Disconnect the engine and automatic transaxle. (ATX) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION.)
2. Disconnect the engine and manual transaxle. (MTX) (See MANUAL TRANSAXLE REMOVAL/INSTALLATION.)
3. Remove the intake-air system. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
4. Remove the exhaust system. (See EXHAUST SYSTEM REMOVAL/INSTALLATION.)
5. Remove the generator.
6. Remove the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION.)
7. Remove the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION.)
8. Assemble in the reverse order of disassembly.
Engine removal/installation
Warning
Fuel vapor is hazardous. It can very easily ignite, causing
serious injury and damage. Always keep sparks and flames away from fuel.
Fuel line spills and leakage are dangerous. Fuel c ...
Other materials:
Mazda 6 Service Manual: Seat Operation
1. Seat Slide
(Manual Seat)
To move a seat forward or backward, raise the lever and slide the seat to the
desired position and release the lever.
Make sure the lever returns to its original position and the seat is locked in
place by attempting to push it forward and backward.
(Power Seat) ...
Mazda 6 Service Manual: Refrigerant system service procedures
GAS CHARGING SET INSTALLATION
1. Fully close the valves of the SST (49 C061 001).
2. Connect the SSTs (49 C061 002, 49 C061 003) to the high- and
low-pressure side joints of the SST (49 C061 001).
3. Connect the SSTs (49 C061 006A, 49 C061 007) to the ends of the
SSTs (49 C061 002, 49 C061 00 ...