Mazda 6 Owners Manual: Erasing Programmed HomeLink Buttons
To erase the existing programming from all three operating channels, press and
hold the two outside buttons ( 
,
) on the auto-dimming mirror until the HomeLink
indicator light begins to flash after approximately 10 seconds.
Verify that the programming has been erased when you resell the vehicle.
Reprogramming the HomeLink system
To program a device to HomeLink using a HomeLink button previously trained, follow
these steps:
1. Press and hold the desired HomeLink button. DO NOT release the button.
2. The indicator light wil ...
Brake
...
Other materials:
Mazda 6 Owners Manual: Rear door removal/installation
Warning
Handling the side air bag sensor improperly can accidentally
deploy the side air bag module, which may seriously injure you. Read AIR BAG
SYSTEM SERVICE WARNINGS before working around the B-pillar areas. (See
SERVICE WARNINGS.)
Note
The side air bag sensor is located in t ...
Mazda 6 Owners Manual: Light switch inspection
Light switch LH side
1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION)
2. Inspect for continuity between the light switch terminals using an
ohmmeter.
If not as specified, replace the light switch.
Headlight switch
Turn switch
Light switch RH side
1. Remove th ...