Mazda 6 Owners Manual: Brake

Erasing Programmed HomeLink Buttons

To erase the existing programming from all three operating channels, press and hold the two outside buttons ( , ) on the auto-dimming mirror until the HomeLink indicator light begins to flash aft ...

Brake System

...

Other materials:

Mazda 6 Owners Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

Mazda 6 Owners Manual: Drive shaft (atx) disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Boot Band (Wheel Side) Disassembly Note Note The boot band does not need to be removed unless it is being replaced. Remove the boot clamp with end clamp pliers as shown and discard the cla ...