Mazda 6 Service Manual: Foreword
- Always perform basic power window system inspection before troubleshooting.
- Troubleshooting gives content unique to trouble caused by problems in the automatic window return function.
Intermittent concern troubleshooting
Vibration Method
If malfunction occurs or becomes worse while driving on a rough road or
when engine is vibrating, perform the steps below.
Note
There are several reasons why vehicle or ...
Basic power window system inspection
Manual Mode Function Inspection
Automatic Mode Function Inspection
Automatic Window Return Function Inspection
IG OFF Timer Function Inspection
Two-step Down Function Inspection
The ...
Other materials:
Mazda 6 Service Manual: No.8 brake system warning light stays on more than 4 seconds with ignition
switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure co ...
Mazda 6 Service Manual: Rear oil seal
REAR OIL SEAL REPLACEMENT
1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION)
2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear Oil Seal Installation Note
...