Mazda 6 Service Manual: Troubleshooting [power window system]
Mazda 6 Service Manual / Body / Troubleshooting [power window system]
- Intermittent concern troubleshooting
- Foreword
- Basic power window system inspection
- Troubleshooting index
- No. 1 driver-side front window does not go up and down in automatic mode
- No. 2 driver-side front window does not reverse, even when encountering a foreign object in its path
- No. 3 driver-side front window reverses even though the glass does not encounter a foreign object while it is going up in automatic mode
Cowl panel removal/installation
1. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND
BLADE REMOVAL/INSTALLATION.)
2. Remove the cowl grille.
3. Remove the windshield wiper motor. (See WINDSHIELD WIPER MOTO ...
Intermittent concern troubleshooting
Vibration Method
If malfunction occurs or becomes worse while driving on a rough road or
when engine is vibrating, perform the steps below.
Note
There are several reasons why vehicle or ...
Other materials:
Mazda 6 Service Manual: General procedures
PRECAUTION (CLUTCH)
Clutch Pipe Removal/Installation
Note
A common reservoir is used for the clutch and brake system fluid.
1. If clutch pipes have been disconnected any time during the procedure, add
clutch fluid (brake fluid), bleed the air, and inspect for leakage after the
procedure ...
Mazda 6 Service Manual: Crankshaft position (ckp) sensor inspection
Note
Perform the following inspection only when directed.
Resistance Inspection
1. Disconnect the CKP sensor connector.
2. Measure the resistance between CKP sensor terminals A and B using an
ohmmeter.
If not as specified, replace the CKP sensor.
If CKP sensor resistance is okay, bu ...
© 2016-2026 Copyright www.mazda6info.net