Mazda 6 Service Manual: Front beltline molding installation

Mazda 6 Service Manual / Body / Molding / Front beltline molding installation

1. Press the clip into the body.

2. Press in the B section of the front beltline molding along the direction (1) shown in the figure to attach it to the body.

Note

If the front beltline molding is difficult to attach, apply soapy water.

Front beltline molding removal

Note When removing the front beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one. 1. Pull the A section upward and remove the clip. 2. Rotate the ...

Rear beltline molding removal

Note When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one. 1. Pull the A section upward and remove the clip. 2. Rotate the B ...

Other materials:

Mazda 6 Service Manual: Call Interrupt
A call can be interrupted to receive an incoming call from a third party. When is selected or the pickup button on the steering wheel is pressed, the current call is held and the system switches to the new incoming call. When is selected, the current call is ended and the system switches t ...

Mazda 6 Service Manual: Location index
INTAKE-AIR SYSTEM FUEL SYSTEM Engine Room Side Fuel tank side EMISSION SYSTEM Engine room side CONTROL SYSTEM ...