Mazda 6 manuals

Mazda 6 Service Manual: Front side turn light removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Front side turn light removal/installation

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Front turn light removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. ...

Front fog light aiming
1. Adjust the tire air pressure to the specification. 2. Position the unloaded vehicle on a flat, level surface. 3. Seat one person in the drivers seat. 4. Position the vehicle 3 m {10 ft} in front ...

Other materials:

Mazda 6 Service Manual: Variable intake-air system (vis) shutter valve actuator inspection (l3)
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 2. Disconnect the vacuum hose from the VIS shutter valve actuator. 3. Connect a vacuum pump to the VIS shutter valve actuator. 4. Apply vacuum and verify that the rod moves. If the rod dose not move, replace the intake ma ...

Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over. 2. Disengage clips A using a fastener remover. 3. Pull the A-pillar trim, then disengage clip B (1). 4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar trim (2). 5. Pull clip B out, then rotate 45°. 6. Remove clip B from the grommet b ...

© 2016-2026 Copyright www.mazda6info.net