Mazda 6 Service Manual: Ignition coil inspection
Primary Coil Winding
1. Remove the ignition coil.
2. Measure the resistance between the following lead holes using an ohmmeter.
- A and B, B and C
- If not specified, replace the ignition coil.
Specification
0.49-0.57 ohms [20°C {68°F}]
Secondary Coil Winding
1. Remove the ignition coil.
- 1 and 4
- 2 and 3
- If not specified, replace the ignition coil.
Specification
9.5-11.1kilohms
Insulation Resistance of Case
1. Disconnect the high-tension lead.
2. Disconnect the ignition coil connector.
3. Measure the insulation resistance between the following terminals and ignition coil case using an ohmmeter.
- Terminal B and ignition coil case.
- If not specified, replace the ignition coil.
Specification
Above 10 Megohm
Ignition coil removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
...
Spark plug removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. ...
Other materials:
Mazda 6 Service Manual: Control Switches
AUTO switch
By pressing the AUTO switch the following functions will be automatically controlled
in accordance with the selected set temperature:
Airflow temperature
Amount of airflow
Selection of airflow mode
Outside/Recirculated air selection
Air conditioner operation
NOTE
AUTO ...
Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. Disconnect the high-tension lead.
4. Remove the spark plugs using the plug-wrench.
5. Install th ...