Mazda 6 Service Manual: Engine electrical system

Engine control system operation inspection

Main Relay Operation Inspection Verify that the main relay clicks when the ignition switch is turned to ON position and off. If there is no operation sound, inspect the following. - Main ...

Location index

...

Other materials:

Mazda 6 Service Manual: Removal/Installation
To remove the head restraint, pull it up while pressing the stop-catch. To install the head restraint, insert the legs into the holes while pressing the stop-catch. WARNING Always drive with the head restraints installed when seats are being used and make sure they are properly installed: Dri ...

Mazda 6 Service Manual: On-board diagnostic test
DTCs Reading Procedure 1. Perform the necessary vehicle preparation and visual inspection. 2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 3. Retrieve DTCs by WDS or equivalent. Pending Trouble Code Access Procedure 1. Perform the necessary ...