Mazda 6 Service Manual: Charging system

Location index

...

Battery removal/installation

1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: No.5 tcs off light does not illuminate with ignition switch on
Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure co ...

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...