Mazda 6 Service Manual: Spark plug inspection
Caution
- Do not inspect, adjust, or clean the plug gap with a wire brush. Doing so can damage the platinum tip.
- When cleaning a spark plug with a plug clear, clean the plug quickly for less than 20 seconds with air pressure below 58.8 kpa {6.0 kgf/cm, 8.5 psi}. Verify that there is no carbon, sand, etc. in the spark plug after cleaning.
Spark plug removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. ...
High-tension lead removal/installation
Caution
The high-tension leads must be reinstalled to their original
position.Incorrect installation can damage the leads and cause power loss, and
negatively affect the electronic components.
1 ...
Other materials:
Mazda 6 Service Manual: Starting procedure for on-board diagnostic test mode
Note
All DTCs displayed in the on-board diagnostic test mode should be
entered in the Audio Repair Order Form.
1. Turn the ignition switch to the ACC or ON position.
2. First press the POWER button, then simultaneously press the AM button and
TAPE/MD button for 2 seconds or more.
N ...
Mazda 6 Service Manual: Operating Tips for Audio System
WARNING
Always adjust the audio while the vehicle is stopped: Do not adjust
the audio control switches while driving the vehicle. Adjusting the audio while
driving the vehicle is dangerous as it could distract your attention from the vehicle
operation which could lead to a serious accident. E ...