Mazda 6 manuals

Mazda 6 Service Manual: High-tension lead removal/installation

Mazda 6 Service Manual / Engine electrical system / Ignition system / High-tension lead removal/installation

Caution

The high-tension leads must be reinstalled to their original position.Incorrect installation can damage the leads and cause power loss, and negatively affect the electronic components.

1. Disconnect the negative battery cable.

2. Remove the plug hole plate.

3. Remove the high-tension lead.

4. Install the high-tension lead.

Spark plug inspection
Caution Do not inspect, adjust, or clean the plug gap with a wire brush. Doing so can damage the platinum tip. When cleaning a spark plug with a plug clear, clean the plug quickly for less ...

Starting system
...

Other materials:

Mazda 6 Service Manual: Front door speaker inspection
1. Inspect for resistance between the front door speaker terminals using an ohmmeter. If not as specified, replace the front door speaker. 2. To verify that the front door speaker outputs sound, apply voltage to the front door speaker and release using a 1.5-V battery. If not outp ...

Mazda 6 Service Manual: Cigarette lighter removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Socket Removal Note 1. Insert a tape-wrapped screwdriver into the socket hole, then press against the ring protrusion to lift the socket toward you. 2. As ...

© 2016-2026 Copyright www.mazda6info.net