Mazda 6 Service Manual: Starting system

High-tension lead removal/installation

Caution The high-tension leads must be reinstalled to their original position.Incorrect installation can damage the leads and cause power loss, and negatively affect the electronic components. 1 ...

Starter removal/installation

Warning When the battery cables are connected, touching the vehicle body with starter terminal B will generate sparks. This can cause personal injury, fire, and damage to the electrical component ...

Other materials:

Mazda 6 Service Manual: Air intake actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air intake actuator. 2. Verify that the air intake actuator operates as shown below. If not as specified, replace the air intake actuator. ...

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...