Mazda 6 Service Manual: Light switch removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Light switch removal/installation

1. Disconnect the negative battery cable.

2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

Steering angle sensor inspection

With DSC 1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION) 2. Disconnect the steering angle sensor connector. 3. Connect battery positive voltage to terminal A and ground to termi ...

Light switch inspection

Light switch LH side 1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION) 2. Inspect for continuity between the light switch terminals using an ohmmeter. If not as specified, re ...

Other materials:

Mazda 6 Service Manual: Locking, Unlocking the Doors
NOTE The system may not operate if you are too close to the windows or door handles. If the key is left in the following areas and you leave the vehicle, the doors may be locked depending on the radio wave conditions even if the key is left in the vehicle. Around the dashboard ...

Mazda 6 Service Manual: Dtc c1955, c1956
Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...