Mazda 6 Owners Manual: Manual Switching
Switching to low beams
Shift the lever to the low beam position. The High Beam Control System (HBC) indicator light (green) turns off.
Switching to high beams
Turn the headlight switch to the
position.
The High Beam Control System (HBC) indicator light (green) turns off and the
is illuminated.
To Operate the System
The High Beam Control System (HBC) operates to switch the headlights automatically
between high and low beams after the ignition is switched ON and the headlight switch
is in the AUTO and high bea ...
Blind Spot Monitoring (BSM) (Some models)
The Blind Spot Monitoring (BSM) is designed to assist the driver in checking
the area to the rear of the vehicle on both sides during lane changes by notifying
the driver of the presence of vehicl ...
Other materials:
Mazda 6 Owners Manual: Front door lock actuator inspection
Door Lock Actuator
1. Disconnect the front door lock actuator connector.
2. Apply battery positive voltage to the front door lock actuator terminals
and inspect the operation of the front door lock actuator.
If not as specified, replace the front door lock actuator.
With double locking ...
Mazda 6 Owners Manual: General procedures
PRECAUTION (FRONT AND REAR AXLE)
Wheel and Tire Removal/Installation
1. The removal and installation procedures for the wheels and tires are not
mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m
{9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}
Brake Line Disconnection/Connecti ...