Mazda 6 Owners Manual: Moonroof (Some models)
The moonroof can be opened or closed electrically only when the ignition is switched ON.
WARNING
Do not let passengers stand up or extend part of the body through the open moonroof while the vehicle is moving:
Extending the head, arms, or other parts of the body through the moonroof is dangerous. The head or arms could hit something while the vehicle is moving. This could cause serious injury or death.
Make sure the opening is clear before closing the moonroof:
A closing moonroof is dangerous. The hands, head, or even neck of a person, especially a child, could be caught in it as it closes, causing serious injury or even death.
NOTE
Before washing your Mazda, make sure the moonroof is completely closed so that water does not get inside the cabin area.
After washing your Mazda or after it rains, wipe the water off the moonroof before operating it to avoid water penetration which could cause rust and water damage to your headliner.
Power Window Lock Switch
This feature prevents all power windows from operating, except the driver's power
window. Keep this switch in the locked position while children are in the vehicle.
Locked position (button depresse ...
Tilt Operation
The rear of the moonroof can be tilted open to provide more ventilation.
To fully tilt automatically, momentarily press the tilt/slide switch.
To fully close automatically, momentarily press the til ...
Other materials:
Mazda 6 Owners Manual: Panel light control switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Panel Light Control Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs
of the panel light control switch.
2. ...
Mazda 6 Owners Manual: A-pillar trim removal
1. Turn the seaming welt over.
2. Disengage clips A using a fastener remover.
3. Pull the A-pillar trim, then disengage clip B (1).
4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar
trim (2).
5. Pull clip B out, then rotate 45°.
6. Remove clip B from the grommet b ...