Mazda 6 manuals

Mazda 6 Service Manual: Rear finisher removal/installation

Mazda 6 Service Manual / Body / Exterior attachment / Rear finisher removal/installation

1. Remove the trunk lid trim (4SD).

2. Remove the liftgate lower trim (5HB).

3. Remove the nuts.

4. Pull the rear finisher toward you, then disengage clip A from the body.


5. Install in the reverse order of removal.

Extractor chamber removal/installation
1. Remove the rear bumper. (See REAR BUMPER REMOVAL/INSTALLATION.) 2. Remove the left side trunk side trim. 3. Remove the screw. 4. Squeeze the clips with your fingers and remove the extractor cham ...

Rear spoiler removal/installation
1. Remove the trunk lid trim. (4SD) 2. Remove the liftgate lower trim. (5HB) 3. Remove the bolts. 4. Disconnect the high-mount brake light connector. (4SD) 5. Remove the rear spoiler. 6. Instal ...

Other materials:

Mazda 6 Service Manual: Rear window glass removal
1. For the 4SD, remove the following parts: (1) Remove the headliner. (2) Remove the rear package trim. 2. For the 5HB, remove the following parts. (1) Remove the rear wiper arm and blade. (2) Remove the liftgate lower trim. 3. Apply protective tape along the edge of the body to pr ...

Mazda 6 Service Manual: Discharge headlight service warnings
Discharge headlight bulb service warnings To prevent electrical shock when replacing the discharge headlight bulb, dry hands thoroughly, and carry out work in an area out of rain. When the light switch is on, approx. 25,000 V of high voltage passes through the discharge headlight bulb so ...

© 2016-2026 Copyright www.mazda6info.net