Mazda 6 manuals

Mazda 6 Service Manual: Rear outer handle removal/installation

Mazda 6 Service Manual / Body / Door / Rear outer handle removal/installation

1. Remove the rear door glass.

2. Remove the rear door unit.

3. Remove the rear door latch.

4. Remove the bolts.


5. Detach the rear outer handle and rear door latch rod.

6. With the rear side of the rear outer handle fixed and the outer handle lever pulled out (1), remove the rear side of the rear outer handle from the rear door.


7. Pull out the front side of the rear outer handle from the rear door.

8. Install in the reverse order of removal.

Front outer handle removal/installation
1. Remove the front door glass. 2. Detach the outer handle and front door latch rod. 3. For protector-equipped vehicles, refer to key cylinder removal/installation to remove the protector. 4. Rem ...

Inner handle removal/installation
1. Remove the front door trim. 2. Using a flathead screwdriver, press and hold the hook in the direction indicated by arrow (1), and pull the shaft in the direction indicated by arrow (2), remove ...

Other materials:

Mazda 6 Service Manual: Using LATCH Lower Anchor
Your Mazda is equipped with LATCH lower anchors for attachment of specially designed LATCH child-restraint systems in the rear seats. Both anchors must be used, otherwise the seat will bounce around and put the child in danger. Most LATCH child-restraint systems must also be used in conjunctio ...

Mazda 6 Service Manual: Three-way catalytic converter (twc) inspection
Note Make sure that no HO2S DTCs have been detected. If detected, this inspection is not applicable for TWC inspection. 1. Connect the WDS or equivalent and monitor PIDs as following. Monitor the right TWC using O2S11 PID for upstream HO2S and O2S12 PID for downstream HO2S. 2. Be ...

© 2016-2026 Copyright www.mazda6info.net