Mazda 6 Service Manual: Roof molding installation
1. Attach the roof molding to the T stud at the A section.
2. Press in the roof molding along the direction (1) shown in the figure and attach it to the clip A at the B section.
3. Hook the roof molding to the clip B at the C section, press it in, and attach the roof molding to the clip B.
4. Press the roof molding along the direction (2) shown in the figure and attach it to the clip A at the B section.
5. Attach the roof molding to the T stud at the D section.
Roof molding removal
1. Detach the clips which secure A and B sections of roof molding, using a
screwdriver or equivalent tool.
2. While pulling the roof molding up, detach the fit for the T stat of the A
section a ...
Outside mirror
...
Other materials:
Mazda 6 Service Manual: Panel light control switch inspection
1. Connect the connector to the panel light control switch.
2. Connect the negative battery cable.
3. Measure the voltage at the panel light control switch using voltmeter.
When inspecting terminal B for continuity, disconnect the panel light
control switch connector.
4. If the value are ...
Mazda 6 Service Manual: Rear drain hose removal
1. Remove the headliner.
2. Remove the trunk side trim. (4SD)
3. Remove the trunk side upper trim and trunk side trim. (5HB)
4. Disconnect the rear drain hose from the sunroof frame.
5. Remove the rear drain hose from the clips.
6. Pull the rear drain hose into the room side.
7. Remove the rea ...