Mazda 6 Service Manual: Outside mirror

Roof molding installation

1. Attach the roof molding to the T stud at the A section. 2. Press in the roof molding along the direction (1) shown in the figure and attach it to the clip A at the B section. 3. Hook the roof ...

Power outside mirror removal/installation

1. Disconnect the negative battery cable. 2. Remove the inner garnish. 3. Remove the front door trim. 4. Disconnect the power outside mirror connector. 5. Remove the screws and the mirror retent ...

Other materials:

Mazda 6 Service Manual: Rear map light removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Rear Map Light Removal Note 1. Insert a tape-wrapped flathead screwdriver into the gap between the headliner and the rear map light. 2. Push the hooks to re ...

Mazda 6 Service Manual: Front upper arm removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-sensor (axle side) and fix it to an appropriate pl ...