Mazda 6 Service Manual: Seat belt

Floor covering

FRONT FLOOR COVERING REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION.) 3. Remove the rear seat. 4. Remove the front s ...

Front seat belt removal/installation

Warning Handling the front seat belt (pre-tensioner seat belt) improperly can accidentally deploy the pre-tensioner, which may seriously injure you. Read SERVICE WARNINGS before handling the ...

Other materials:

Mazda 6 Service Manual: Wheel hub bolt replacement
1. Remove the hub bolt using the SSTs. Note If the dust cover interferes with the wheel hub bolt and the wheel hub bolt cannot be removed, tap the part shown in the figure with a chisel lightly and bend the processing point back to the steering knuckle side. 2. Install the hub bolt i ...

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable. 2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness connector with the ignition switch off. 3. Attach the tester leads to the SST and inspect voltage referring the table below. Terminal Voltage Table (Reference) (Engine is idling, and co ...