Mazda 6 Owners Manual: Shift-Lock System
The shift-lock system prevents shifting out of P unless the brake pedal is depressed.
To shift from P:
1. Depress and hold the brake pedal.
2. Start the engine.
3. Press and hold the lock-release button.
4. Move the selector lever.
NOTE
- When the ignition is switched to ACC or the ignition is switched off, the selector lever cannot be shifted from P.
- The ignition cannot be switched to OFF if the selector lever is not in P.
Automatic Transaxle Controls
Various Lockouts:
Indicates that you must depress the brake
pedal and hold in the lock-release button to shift (The ignition must be switched
ON).
Indicates the shift lever can be shifted ...
Shift-Lock Override
If the selector lever will not move from P using the proper shift procedure,
continue to hold down the brake pedal.
1. Remove the shift-lock override cover using a cloth-wrapped flat head screwdriv ...
Other materials:
Mazda 6 Owners Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning
When the transaxle and ATF are hot, they can badly burn. Turn off
the engine and wait until they are cool before replacing the ATF.
1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.)
2. Disconnect the TFT sensor connector.
3. Remove the TFT sensor.
4. Install a TFT senso ...
Mazda 6 Owners Manual: Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along
the direction (1) shown in the figu ...