Mazda 6 Service Manual: Sunroof unit disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the deflector.
3. Remove the glass panel.
4. Disassemble in the order indicated in the table.
5. Assemble in the reverse order of disassembly.
Slider Disassembly Note
1. Remove the screw.
2. Slide the slider rearward, and remove it from the sunroof frame.
Guide Disassembly Note
Slide the guide rearward, and remove it from the sunroof frame.
Decoration Link Assembly Note
Set the pin in the decoration link.
Guide Assembly Note
1. Move the guide by hand until it comes to the front stopper.
2. Move the guide by hand until center of pin comes between mark A and B.
Sunroof unit removal/installation
1. Disconnect the negative battery cable.
2. Remove the headliner.
3. Remove the glass panel.
4. Disconnect the front and rear drain hose from the sunroof frame.
5. Remove the bolt A, and then rem ...
Sunroof motor removal
1. Disconnect the negative battery cable.
2. Remove the headliner.
3. Disconnect the connector.
4. Remove the screws, and then remove the sunroof motor.
...
Other materials:
Mazda 6 Service Manual: Liftgate disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim.
3. To remove the liftgate outer handle and liftgate key cylinder, remove the
rear finisher.
4. To remove the stud ball, separate the stud ball and the stay damper.
5. Disassemble in the order indicated in the table.
...
Mazda 6 Service Manual: Side protector removal
1. Pry the side protector end 20-30 mm {0.8-1.1 in} using a flathead
screwdriver or a razor.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
Note
The side protector is installed with double-sided adhesive tape.
If the side protector ...