Mazda 6 Service Manual: Rear washer nozzle adjustment
Insert a needle or an equivalent tool into the spray hole of the rear washer nozzle and adjust the nozzle direction as shown.
REAR WASHER NOZZLE CLEANING
Clean the rear washer nozzle. (See WINDSHIELD WASHER NOZZLE CLEANING.)
Rear washer nozzle removal/installation
1. Disconnect the negative battery cable.
2. Remove the liftgate upper trim. (See LIFTGATE UPPER TRIM
REMOVAL/INSTALLATION)
3. Remove the rear washer hose from the rear washer nozzle.
4. Compress ...
Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the ...
Other materials:
Mazda 6 Service Manual: Transmitter battery inspection
Caution
Since the battery voltage does not drop fully if the button is
pushed for only 4 seconds or less, it can not be properly examined to see
whether it is good or bad. Always push the button for 5 seconds.
Note
A correct measurement can not be obtained if the battery
temperat ...
Mazda 6 Service Manual: Solenoid valve inspection
Resistance Inspection (On-Vehicle Inspection)
Caution
Water or foreign objects entering the connector can cause a poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
1. Disconnect the negative battery cable.
2. Remove the ...