1. Disconnect the negative battery cable.
2. Remove the liftgate upper trim. (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION)
3. Remove the rear washer hose from the rear washer nozzle.
4. Compress the tabs of the rear washer nozzle.
5. Pull the rear washer nozzle out to remove it.
6. Install in the reverse order of removal.
7. Adjust the rear washer nozzle. (See REAR WASHER NOZZLE ADJUSTMENT.)
Mazda 6 Service Manual: Climate control unit installation
1. Pass each wire through the following routes then connect to A/C unit.
(Manual air conditioner)
2. Connect the climate control unit connectors. (Manual air conditioner)
3. Install the climate control unit to the center panel. (Full-auto air
conditioner)
4. Install the center panel.
5. Ad ...
Mazda 6 Service Manual: Inspection of dtcs for operation mode
Note
The cruise set indicator light will illuminate for 3 seconds? when
operation mode is on.
If the cruise set indicator light does not illuminate for 3
seconds (Operation mode is not on)? the following may be the cause of the
malfunction:
- Cruise actuator ignition power suppl ...