Mazda 6 Service Manual: Exterior attachment

Rear bumper removal/installation

1. Disconnect the negative battery cable. 2. Remove the rear combination light. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Bumper Removal N ...

Radiator grille removal/installation

1. Remove the screws. 2. Press clip A in the direction of the arrow, pll the radiator grille outward and remove from the front bumper. 3. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: Sunroof relay inspection
Note Sunroof relay is built in the sunroof motor. 1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.) 2. Connect the sunroof switch connector. 3. Measure the voltage at the sunroof relay terminals as indicated below. 4. Disconnect the sunroof relay connector before inspecting fo ...

Mazda 6 Service Manual: Rear drain hose installation
Caution If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and the headliner, always make sure there is no interference with the rear drain hose. Fix any problem if foun ...