Mazda 6 manuals

Mazda 6 Service Manual: Manual transaxle

Mazda 6 Service Manual / Manual transaxle

Flywheel
FLYWHEEL INSPECTION 1. Install a dial gauge on the cylinder block. 2. Measure the flywheel runout using a dial indicator. If the runout is excessive, replace the flywheel. Runout 0.1 m ...

Location index
MANUAL TRANSAXLE LOCATION INDEX ...

Other materials:

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable. 2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness connector with the ignition switch off. 3. Attach the tester leads to the SST and inspect voltage referring the table below. Terminal Voltage Table (Reference) (Engine is idling, and co ...

Mazda 6 Service Manual: Starting procedure for on-board diagnostic test mode
Note All DTCs displayed in the on-board diagnostic test mode should be entered in the Audio Repair Order Form. 1. Turn the ignition switch to the ACC or ON position. 2. First press the POWER button, then simultaneously press the AM button and TAPE/MD button for 2 seconds or more. N ...

© 2016-2026 Copyright www.mazda6info.net