To Stop the Alarm
Break-In PeriodMazda 6 Owners Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket.
2. Disconnect the DSC HU/CM connector.
3. Connect the SST (49 G066 004) to the DSC HU/CM connector and
harness side connector.
4. Inspect voltage referring the table below.
Terminal Voltage Table (reference value)
(Ignition switch is at ON, and conne ...
Mazda 6 Owners Manual: Liftgate side trim removal/installation
1. Remove the liftgate upper trim.
2. Position the strap hanger as shown in the figure.
3. Pull the liftgate side trim toward you, then disengage clips A, pin B and
the strap hanger from the body and pin B, hook C, D from the liftgate lower
trim.
4. Remove the liftgate side trim.
5. Remo ...