Mazda 6 Service Manual: Dtc 09:er22

Dtc table

*1,*2 : When an error occurs, the error messages are displayed three times in the order of *1 and *2, respectively. ...

Dtc 09:er20

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Service Manual: Heating
1. Set the mode selector dial to the position. 2. Set the air intake selector to the outside air position (indicator light turns off). 3. Set the temperature control dial to the hot position. 4. Set the fan control dial to the desired speed. 5. If dehumidified heating is desired, turn on the ...